Fog Lamp Bulb Replacement

Remove or Disconnect
- Make sure the fog lamp switch is in the OFF position.
1. Two screws and lens trim panels from the front of the fog lamp assembly.
2. Pull the lamp and lens assembly forward from the housing and turn it over.
3. White wire connector inside the braided insulator.
A. Leave the ground wire connected.
B. Note the position of the wire clip at the lamp and lens assembly. then squeeze the edges of the clip together to remove it.

CAUTION: Halogen bulbs contain a gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
- Always wear eye protection when changing a halogen bulb.
- Turn the lamp switch OFF and allow the bulb to cool before changing it. Leave the switch OFF until the change is complete.
- Handle the bulb only by its base. Avoid touching the glass.
- Do not drop or scratch the bulb. Keep moisture away.
- Place the used bulb In the new bulb's carton and dispose of it properly.

4. Lift out the halogen bulb.

Install or Connect

NOTICE: A void touching the bulb or letting it come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when it is turned on. If either comes in contact with the bulb, clean it with alcohol or a suitable degreaser and wipe the bulb dry.

1. White wire connector to the wiring in the braided insulator.
2. Bulb assembly into the back of the lamp and lens assembly.
3. Wire clip to hold the bulb in place.
- Make sure the bulb is firmly in position. The bulb assembly must not be loose.
4. Lamp and lens assembly into the housing.
5. Lens trim panels with screws.