Engine - Revised Replacement Procedure

File In Section: 06 - Engine/Propulsion System

Bulletin No.: 99-06-01-006

Date: May, 1999

SERVICE MANUAL UPDATE

Subject:
Revised Engine Replacement Procedure

Models:
1995-98 Chevrolet and GMC M/L Models

This bulletin is being revised to update information on the engine replacement procedure as indicated below. Please discard Corporate Bulletin Number 56-61-02 (Section 6 - Engine Mechanical).

This bulletin is being issued to revise the Engine Replacement procedure in the Engine Mechanical subsection of the 199598 M/L Service Manuals.

Important:

^ The Twin Post Hoist Assembly Support Bar, J 41617, is not available.

^ This procedure must be performed on a side lift hoist. The engine and front frame assembly will be removed out of the bottom of the vehicle. Do not use a single post hoist or a twin post hoist in order to perform this procedure.

Please make the following revisions:

^ Remove tool J 41817 Twin Post Hoist Frame Assembly Support Bar from the Tools Required list at the beginning of the procedure.

^ Remove the information under the title Twin Post Hoist.

^ Remove the Twin Post Hoist figure.