Air Door Cable: Service and Repair

Temperature And Defrost Control Cable:

Remove or Disconnect

1. Roll instrument panel back.
2. Control assembly.
3. Electrical connector.
4. Temperature cable from the heater control assembly.
5. Temperature cable from the temperature valve.
A. Release cable from the temperature valve by squeezing retainer.
B. Squeeze post and lift cable end to remove.

Install or Connect

1. index the cable before installing.
A. Cycle the temperature rotary knob to full COLD.
B. Make sure the temperature door is closed.
2. Cable to the temperature valve.
A. Snap the cable onto the valve.
B. Secure the cable by snapping it into the heater case.
3. Temperature cable to the control assembly.
- Route the cable in the same location as removed.
4. Electrical connector.
5. Control assembly.
6. Roll instrument panel forward.