Cluster Assembly

The Instrument Panel (I/P) Cluster Assembly receives power from either one or two IP Fuse Block sources. If Automatic Transmission, power runs from the TRANS fuse 20, through CKT 1020 (PNK) to pin 7 of the IP Cluster connector. If Manual Transmission, power runs from the GAUGES fuse 4, through CKT 39 (PNK) to pin 7 of the I/P Cluster connector. In both cases, the GAUGES fuse 4 supplies power to pin 22 of the I/P Cluster connector.

Power coming in through pin 7 of the I/P Cluster supplies voltage to the Tachometer, Electric Speedometer, PRNDL Indicator, and the Check Gauges Lamp Driver. Pin 22 of the I/P Cluster carries power to the remaining components within the I/P Cluster Assembly.

Ground for the I/P Cluster Assembly goes through two pins. One is pin 4, the other is pin 31. Both run to splice S215 and onto ground G104 and G103 (Gas Only).