Oil Pump Assembly Installation

INSTALLATION PROCEDURE

- Tools Required
- J 25025-1 Alignment Pins
- J 39855-2 Stator Shaft Seals Installation Sizer





1. Install the pump assembly alignment pins.





2. Remove the J 39855-2 stator shaft seal sizer.
3. Install the thrust pump to drum washer.
4. Use TRANSJEL(r) J 36850 or equivalent to retain the washer to the pump.





5. Install the pump cover to case gasket.
6. Install the oil pump to case seal on the pump.
7. Install the oil pump assembly into the case and align all holes properly.





8. Install the pump to case bolts.
- Tighten the bolts to 24 Nm (18 ft. lbs.).

9. Remove the pump alignment pins.





10. Install the remaining pump to case bolts, in the holes where the pump alignment pins were.
- Tighten the bolts to 24 Nm (18 ft. lbs.).