Engine Wiring Harness Assembly Installation

^ Tools Required
- J 41515-A Glow Plug Socket
- J 39083 Glow Plug Connector Tool





1. Install the crankshaft position sensor in the front cover (if equipped).

NOTICE: Refer to Fastener Notice in Service Precautions.





2. Install the crankshaft position sensor bolt (if equipped).
Tighten the crankshaft position sensor bolt to 23 Nm (17 ft. lbs.) (if equipped).





3. Install the glow plugs using the J41515-A
Tighten the glow plugs to 22 Nm (16 ft. lbs.).





4. Install the heat shields on cylinders number 4 and 6.
5. Using J 39083 install the jumper wires to cylinders 4 and 6.





6. Place the harness in the engine valley.
7. Plug in or connect all the wiring harness connectors to devices or attachment points.