Clutch Plate and Hub Assembly
Tools Required- J 33013-B Hub and Drive Plate Remover/Installer
- J 33027-A Clutch Hub Holding Tool
- J41790 Compressor Holding Fixture
Removal Procedure
1. Remove the compressor from the vehicle.
2. Clamp the compressor holding fixture, J41790 in a vise and attach the compressor to the J41790.
3. Hold the clutch hub and drive plate assembly (2) in place using the J 33027-A.
4. Remove the compressor shaft nut with a 13 mm socket (1).
5. Thread the J 33013-B into the hub.
6. Remove the hub and drive plate assembly (1) by turning the center screw into the body of the J 33013-B and against the compressor shaft.
7. Remove the shaft key and retain for reassembly.
Tools Required
- J 33013-B Hub and Drive Plate Remover/Installer
- J 33017 Pulley and Bearing Assembly Installer
- J 33027-A Clutch Hub Holding Tool
Installation Procedure
1. Install the shaft key into the hub key groove (4) approximately 3.2 mm (1/8 in) out of the keyway. The shaft key is curved slightly to provide an interference fit in the hub key groove.
2. Clean the surfaces of the clutch plate (1) and the clutch rotor (2) before installing the clutch plate and hub assembly.
3. Align the shaft key with the shaft keyway in the clutch plate and the hub assembly and place onto the compressor shaft (3).
4. Remove the J 33013-B.
4.1. Remove the center screw from the body of the J 33013-B.
4.2. Install the center screw into the opposite end of the J 33013-B.
5. Install the J 33013-Band bearing tools (1) onto the clutch plate (3) and the hub assembly (2).
5.1. Back the body of the J 33013-B off enough to allow the center screw to be threaded onto the end of the compressor shaft.
5.2. Thread the center screw several turns onto the end of the compressor shaft.
Do not tighten the center screw on the compressor shaft.
6. Hold the center screw with a wrench.
6.1. Tighten the hex portion of the J 33013-B body several turns.
6.2. Remove the J 33013-B from the clutch plate and hub.
6.3. Make sure that the shaft key is still in place in the keyway.
7. Reinstall the J 33013-B.
Important: Make sure that the air gap is even all around the clutch plate and hub assembly.
9. Tighten the hex portion of the J 33013-B until the air gap between the clutch plate and clutch rotor is 0.40 mm (0.015 in).
10. Remove the J 33013-B.
11. Hold the clutch plate and hub assembly (2) with the J 33027-A.
12. Install the compressor shaft nut.
Tighten
Tighten the compressor shaft nut to 17.5 N.m (13 lb ft).
13. Spin the pulley rotor by hand to make sure the rotor is not rubbing against the clutch drive plate.
14. Remove the compressor from the J 41790.
15. Install the compressor into the vehicle.