Rear Housing Assemble (Rear Wheel Drive)

REAR HOUSING ASSEMBLY

^ Tools Required
- J 36190 Driver Handle
- J 36503 Output Shaft Oil Seal Installer
- J 36506 5th and Reverse Detent Bushing Remover/Installer





1. Install the rear housing shift shaft bearing. Use J 36506 and J 36190.
1.1. The writing on the bearing lip should face down.
1.2. Install the bearing flush with the housing surface.





2. Install 2 dowel pins in the housing flange. Drive the dowel pins rearward and flush with the flange surface.





3. Install the slip yoke oil seal. Use J 36503.





4. Fill the space between the seal lips with chassis grease. Use GM P/N 1052497 or equivalent.