Door Jamb Switch Replacement - Rear

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Remove the battery negative cable.
2. Use a flat bladed tool in order to remove the door jamb switch from the rear door hinge-pillar.
3. Disconnect the electrical connector. Tape the wires to the body in order to prevent them from dropping into the rear door hinge-pillar.

INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the door jamb switch to the rear door hinge-pillar.
3. Connect the battery negative cable.