Underhood Lamp: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Remove the negative battery cable.
2. Disconnect the electrical connector.
3. Disconnect the following components from the hood:
^ The screw
^ The star washer
^ The ground wire
4. Remove the screws that retain the underhood lamp to the hood.
5. Remove the underhood lamp assembly from the vehicle.

INSTALLATION PROCEDURE
1. Install the underhood lamp assembly to the vehicle.
2. Install the screws that retain the underhood lamp to the hood.

Tighten
Tighten the screws to 1.9 N.m (17 lb in).

3. Install the following components to the hood:
^ The ground wire
^ The washer
^ The screw

Tighten
Tighten the screws to 1.9 N.m (17 lb in).

4. Connect the electrical connector.
5. Connect the negative battery cable.