Compressor Hose Assembly
Removal Procedure1. Disconnect the negative battery cable.
2. Recover the refrigerant from the system.
4. Remove the compressor and condenser hose from the compressor.
5. Remove the sealing washers.
6. Remove the compressor and condenser hose from the accumulator.
7. Remove the O-ring seal.
8. Remove the lower radiator hose.
9. Remove the compressor and condenser hose from the condenser.
10. Remove the O-ring seal.
Installation Procedure
1. Install a new O-ring seal.
Coat the O-ring seal with 525 viscosity refrigerant oil.
2. Install the compressor and condenser hose to the condenser.
Tighten
Tighten the hose to 24 N.m (18 lb ft).
3. Install the lower radiator hose.
4. Install a new O-ring seal.
Coat the O-ring with 525 viscosity refrigerant oil.
5. Install the compressor and condenser hose to the accumulator.
Tighten
Tighten the hose to 41 N.m (30 lb ft).
6. Install the sealing washers.
7. Install the compressor and condenser hose to the compressor.
8. Install the compressor and condenser hose washer and the bolt.
Tighten
Tighten the bolt to 33 N.m (24 lb ft).
9. Connect the negative battery cable.
10. Add refrigerant to the system.
11. Inspect the system for leaks.