4L60-E Automatic Transmission

REMOVAL PROCEDURE





1. Raise the vehicle. Suitably support the vehicle.
2. Disconnect the electrical connector from the sensor.
3. Remove the bolt.
4. Remove the sensor and the O-ring seal.
5. Inspect the seal and the transmission case. Replace the seal, if necessary.

INSTALLATION PROCEDURE





1. Install the sensor and the O-ring seal to the transmission.
2. Install the bolt.
^ Tighten the bolt to 11 Nm (97 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Connect the electrical connector to the sensor.
4. Lower the vehicle.