Inner Console Cover Replacement

Important
For additional information, see the Instrument Panel and Console subsection in the Body and Accessories section of the appropriate service manual.





1. Open the floor console cover and remove the six torx head screws (1) and the three phillips head screws (2) that attach the inner console cover to the outer console cover.

2. Separate the inner console cover (3) from the outer cover (4) and discard the inner cover. It is not necessary to remove the console outer cover from the hinge assembly.

3. Install the new inner console cover to the outer console cover.

4. Install the three phillips head screws (2) and then the six torx head screws (1). Tighten all screws to 1.5 Nm (13 lb in).

5. Close the console cover and verify that the latch operates properly.

6. Install the GM Campaign Identification Label.