Low and Reverse Clutch Spacer Plate Selection

1. Inspect the lo and reverse clutch plates for the following conditions:
- Composition material wear
- Composition material heat damage
- Composition material delamination
- Steel plates heat damage
- Steel plates surface finish damage





2. Stack the lo and reverse clutch plate assembly on a flat surface in the following order:
2.1. One waved plate
2.2. Five composition and four steel plates, starting with one composition plate and alternating with steel.
2.3. Lo and reverse clutch support





3. Measure the height of the clutch pack from the work surface to the top of the lo and reverse clutch support.
4. Refer to Low and Reverse Clutch Spacer Plate Selection in order to select the proper thickness of the lo and reverse clutch selective spacer plate.
5. Install the proper selective spacer plate between the wave plate and the first composition clutch plate, with the identification side up.
6. The overall height for the clutch pack including the selective spacer plate should be 29.22-29.90 mm (1.15-1.18 inch).