Differential Assembly Installation

^ Tools Required
- J 8092 Driver Handle
- J 33788 Output Shaft Bearing Installer
- J 23423-A Side Bearing Cup Installer
- J 33792 Side Bearing Adjuster Socket
- J 42211 Bearing Installer
- J 42213 Side Bearing Adjuster Socket





1. Install the bearing into the right sleeve using the J 33788.





2. Install the bearing into the left sleeve using the J 42211.
3. Install the sleeves into the carrier. Thread the sleeves in completely.





4. Install the side bearing cups into the carrier using the J 23423-A and the J 8092.





5. Install the differential case assembly to the carrier.
5.1. Place the differential case assembly into the carrier half that contains the pinion gear.
5.2. Turn the left sleeve in toward the differential case using the J 42213 until backlash is felt between the ring and pinion gear.
6. Assemble the carrier halves. Do not use sealer at this time.





7. If the carrier halves do not contact completely, back out the right hand adjusting sleeve. Use the J 33792.
8. Install the four carrier halves assembly bolts.
^ Tighten the bolts to 50 Nm (37 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.