Linear Shift Assembly - Removal - Column Shift

^ Tools Required:
- J 41352 Modular Column Holding Fixture
- J 41396 Park Lock Cable Pliers

NOTICE: Linear shift assembly (40)maybe removed as an assembly or certain components may be disassembled as necessary to do repairs. Remove or disassemble only those components necessary to do repairs.

REMOVE OR DISCONNECT
1. Do all steps, "REMOVE OR DISCONNECT", Upper/Lower Shroud, STEERING Column Lock CYL Set (With Key).
2. Park lock cable assembly (48) from lock module assembly (15).
^ Lock cylinder should be in "OFF-LOCK" position and gear shift in "PARK" position.
^ Insert small blade screwdriver into slot in lock module assembly (15). Push against locking tab on end of cable assembly (48) and remove.





3. Pry actuator arm of electrical (BTSI) actuator (61) from outer shift cable ball stud on cable shift cam assembly (44) and mounting pin on jacket (58).
4. Transaxle cable from inner shift cable ball stud on cable shift cam assembly (44).
5. Three flat head 6 -lobed socket tap screws (43).
^ Shift column to "NEUTRAL" position to gain access to lower socket tap screw (43).
6. Linear shift assembly (40) from column.


INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Linear shift assembly (40) to column.
2. Three flat head 6-lobed socket tap screws (43).
^ Linear shift assembly (40) must be out of "PARK" position to install lower socket tap screw (43).

Tighten
^ Tighten screws (43) to 10 Nm (89 lb in).

3. Transaxle cable to inner shift cable ball stud on cable shift cam assembly (44).
4. Park lock cable assembly (48) to lock module assembly (15).
^ Lock cylinder should be in "OFF-LOCK" position and gear shift in "PARK" position.
^ Locking tab on end of cable (48) to slot in lock module assembly (15).
5. Actuator arm of electrical (BTSI) actuator (61) to outer shift cable ball stud on cable shift cam assembly (44).
6. Do Adjust and Inspect, "INSTALL OR CONNECT", ELECTRICAL (BTSI) ACTUATOR.






Adjust
^ Park lock cable assembly (48).
A. Gear shift lever installed and in "PARK" position.
B. Ignition in "OFF LOCK" position and remove key.





C. Unlock adjuster ring on cable assembly (48) with tool J 41396
D. Pull on cable until park lock latch contacts gear shift lever.
^ Release the cable.





E. Lock adjuster ring securely in place on cable assembly (48) with tool J 41396






Inspect
^ Park lock cable assembly (48).
A. With lock cylinder in "OFF-LOCK" position, gear shift lever should not be able to shift out of "PARK" position.
B. Insert key and turn to "RUN" position.
C. Shifter in "NEUTRAL" position.
D. With gear shift in "NEUTRAL" position, lock cylinder should not be able to go into "OFF-LOCK" position.
E. Shifter in "PARK" position.
F. Lock cylinder in "OFF-LOCK" position and remove key.
7. Do all steps "INSTALL OR CONNECT", Upper/Lower Shroud, STEERING Column Lock CYL Set (With Key).