Crankshaft Balancer Installation

IMPORTANT: Before installing the crankshaft balancer, check the oil seal contact area for grooving and roughness. Replace the crankshaft balancer if necessary.





1. Tap the crankshaft balancer into place with a mallet.
2. Make sure that the key is in place.
3. Make sure that the crankshaft balancer is completely installed on the crankshaft.

NOTICE: Refer to Fastener Notice in Service Precautions.

4. Install the bolt and the washer.
Tighten the bolt to 270 Nm (200 ft. lbs.).





5. Install the crankshaft pulley and bolts.
Tighten the crankshaft pulley bolts to 50 Nm (37 ft. lbs.).