Oil Pump: Service and Repair

REMOVAL PROCEDURE
1. Open the hood.
2. Disconnect the negative battery cable from the battery.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

3. Drain the crankcase.
4. Remove the oil pan from the engine block.
5. Remove the oil pump retaining bolts from the oil pump.
6. Remove the oil pump assembly from the engine block.





INSTALLATION PROCEDURE

IMPORTANT: When installing the oil pump, always replace the retainer between the oil pump and the shaft.

1. Install the oil pump to the engine block. Refer to Oil Pump, Pump Screen, and Deflector Installation under Engine Unit Repair.
2. Install the oil pump mounting bolts.
Tighten the bolts to 88 Nm (65 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Install the oil pan to the engine block.
4. Connect the battery negative cables to the battery.
5. Close the hood.