Vehicle Control Module (VCM) Replacement/Programming

CAUTION: In order to prevent possible electrostatic discharge (ESD) damage to the VCM, do not touch the connector pins or soldered components on the circuit board.

IMPORTANT NOTES:
- To prevent internal VCM damage, the ignition must be turned OFF before disconnecting or reconnecting power to the VCM (for example, battery cable, VCM fuse, jumper cables, etc.).
- When replacing the production VCM with a service VCM (controller), it is important to transfer the broadcast code and production VCM number to the service VCM label. This will allow positive identification of VCM parts throughout the service life of the vehicle.
- Service of the VCM consists of either replacement of the VCM or reprogramming of the VCM. If the diagnostics call for replacement of the VCM, it will be necessary to transfer the Electronic Spark Control Module (PROM) and program the VCM using the procedure in this section.

IMPORTANT:
^ The PROM / Electronic Spark Control Module must be transferred to the replacement VCM.
^ Do not remove the cover of the PROM. Use of an unapproved PROM removal method may cause damage to the PROM or the socket.
^ The replacement VCM must be programmed before the vehicle will run.
^ The replacement VCM must also have the VTD Password Learn Procedure completed before the vehicle will run.
^ The replacement VCM must also have the CKP System Variation Learn Procedure completed. If this procedure is not completed a DTC P1336 will set.

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

VCM Harness Connections:

2. Remove the connectors from the VCM.
3. Remove the spring retainer off the edge of the VCM.
4. Slide the VCM out of the bracket at an angle.

VCM Access Cover:

5. Remove the PROM/Electronic Spark Control Module access cover.

Removing Knock Sensor Module From PCM:

6. Remove the PROM/Electronic Spark Control Module by gently squeezing the PROM locks together.

INSTALLATION PROCEDURE

IMPORTANT:
- Press only on the ends of the PROM/Electronic Spark Control Module. Gently press on the PROM until it is firmly seated in the socket. Listen for the click.
- In order to prevent possible electrostatic discharge (ESD) damage to the VCM, do not touch the connector pins or soldered components on the circuit board.

1. Align the notches of the PROM/Electronic Spark Control Module with the notches in the PROM socket.




2. Install the PROM in the PROM socket.
3. Install the access cover on the VCM.
4. Install the VCM in the engine compartment.
5. Install the retaining spring over the edge of the VCM.
6. Install the connectors to the VCM.
7. The MIL, antilock and brake lamps will continue to be enabled until the VCM is programmed. Once the programming is complete, the lamps will turn off and normal operation will occur.
8. Connect the negative battery cable.
9. Proceed to the VCM programming.


VCM PROGRAMMING
1. Take the following steps in order to set-up for the VCM (EEPROM) Programming.
^ The battery is fully charged.
^ The ignition is ON.
^ The Data Link Connector (DLC) is secure.
2. Refer to up-to-date Techline terminal and equipment user's instructions in order to program the VCM.
3. If the VCM fails to program, do the following functions:
^ Check all the VCM connections.
^ Check the Techline terminal and equipment for the latest software version.
^ Try again-to program the VCM. If it fails again, replace the VCM.
4. Perform VTD Password Learn Procedure.
5. Perform CKP System Variation Learn Procedure. Crankshaft Position System Variation Learn Procedure
6. For a functional check perform the Powertrain On-Board Diagnostic (OBD) System Check. Testing and Inspection