Balance Shaft Bearing and/or Bushing Removal

^ Tools Required
- J26941 Bushing/Bearing Remover
- J 38834 Balance Shaft Service Kit





1. Use the J 38834 and the J 26941 in order to remove the balance shaft rear bearing.
1.1. Install the J26941 legs behind the balance shaft rear bearing and secure.
1.2. Install the J 38834 - 1 with the short threaded end through the balance shaft bore in the front of the engine block.
1.3. Install the J 38834 - 1 into the J26941.
1.4. Slide the J 38834 - 2 onto the J 38834 - 1 and into the balance shaft bore of the engine block.
1.5. Install the J 38834 bearing, washer, and nut onto the J 38834
1.6. Using a wrench secure the J 38834 - 1 and then rotate the J 38834 nut clockwise until the balance shaft rear bearing is removed from the engine block.
1.7. Remove the J26941 from the balance shaft rear bearing.

2. Discard the balance shaft rear bearing.