Wheel Cover: Service and Repair

REMOVAL PROCEDURE
1. Remove the tire and wheel assembly.
2. Against the back surface of the cap, place a block of wood approximately 50 mm (2 in) in diameter with a squared off end. Remove the cap with a sharp hammer blow on the block of wood.

INSTALLATION PROCEDURE

NOTICE: Failure to hit the cap squarely without the load distributed evenly could result in permanent damage to the cap.

1. Place the cap into position at the wheel opening. Place a block of wood at least 75 mm (3 in) in diameter against the cap face. Install the cap by striking the block of wood with a hammer.
2. Install the tire and wheel assembly.