Balance Shaft Bearing and/or Bushing Installation

^ Tools Required
- J 8092 Universal Driver Handle
- J 38834 Balance Shaft Service Kit
- J 36996 Balance Shaft Installer





1. Use the J 38834 in order to install the balance shaft rear bearing.
1.1. Install the J 38834 - 3 onto the short threaded end of the J 38834 - 1.
1.2. Install the J 38834 nut, the washer, and the bearing on the long threaded end of the J 38834 - 1.
1.3. Install the J 38834 - 2 onto the J 38834 - 1 so that the smaller diameter of the J 38834 - 2 will be facing the front of the engine block.
1.4. Install the J 38834 - 2 on the inside of the balance shaft front bearing bore.
1.5. Lubricate the NEW balance shaft rear bearing with clean engine oil.
1.6. Install the balance shaft rear bearing onto the J 38834 - 2.
1.7. Align the balance shaft rear bearing for installation.
1.8. Using a wrench secure the J 38834 - 1 into place.
1.9. Rotate the J 38834 nut until the balance shaft rear bearing is properly and completely pushed into the balance shaft rear bearing bore.
1.10. Remove the J 38834.

IMPORTANT: The balance shaft and the balance shaft front bearing are serviced only as an assembly. Do not remove the balance shaft front bearing from the balance shaft.





2. Use the J 36996 and the J 8092 in order to install the balance shaft.