Driver Information Center Replacement (Sunroof Equipped)

REMOVAL PROCEDURE



1. Remove the screw at the front of the console that retains the sunroof console to the roof.
2. Pull downward on the rear of the console in order to expose the electrical connections (1, 4, 5 and 6) and remove the sunroof console from the roof.




3. Disconnect the electrical connectors (1, 4, 5 and 6) as needed.
4. Remove the screw that retains the sunroof console mounting bracket to the roof.
5. Release the tabs at the rear of the bracket in order to remove the sunroof console mounting bracket from the roof.

INSTALLATION PROCEDURE




IMPORTANT: Ensure that the Flux Gate wire (4) is not trapped between the retainer and the roof steel.

1. Install the sunroof console bracket to the roof.
2. Install the screw that retains the sunroof console mounting bracket to the roof.

Tighten
Tighten the screw to 1.9 N.m (17 lb ft).




3. Install the electrical connectors (1, 4, 5 and 6) as needed.
4. Insert the console mounting tabs into the mounting bracket and push upward on the rear of the console in order to install the console.
5. Install the screw at the front of the console that retains the console to the root.

Tighten
Tighten the screw to 1.9 N.m (17 lb in).