Instrument Panel Cluster Replacement

REMOVAL PROCEDURE

NOTE: When replacing a speedometer or odometer assembly, federal law requires that the odometer reading of the replacement unit be set to register the same mileage as the prior odometer. It the same mileage cannot be set, the law requires that the replacement odometer be set at zero and a label be installed on the driver's door frame to show the previous reading and the date of replacement.

IMPORTANT: All warning lamps use a Light Emitting Diode (LED). The LED is not serviceable. If a warning lamp's LED stops functioning, exchange the instrument cluster. A serviceable incandescent light is used in the following components:
^ The high-beam indicator
^ The turn signal indicators
^ The dash lights

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the battery negative cable.
2. Remove the instrument panel accessory trim plate.
3. Remove the four screws that retain the cluster to the instrument panel.
4. Disconnect the electrical connectors as needed.
5. Remove the cluster from the instrument panel.

INSTALLATION PROCEDURE
1. Install the cluster to the instrument panel. Firmly seat the cluster onto the connector.
2. Connect the electrical connections as needed.
3. Install the instrument cluster screws.

Tighten
Tighten the screws to 1.9 N.m (17 lb in).

4. Install the instrument panel accessory trim plate.
5. Connect the battery negative cable.