Headlamps Replacement

REMOVAL PROCEDURE




CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
- Turn off the lamp switch and allow the bulb to cool before changing the bulb. Leave the lamp switch off until the bulb change is complete.
- Always wear eye protection when changing a halogen bulb.
- Handle the bulb only by its base. Avoid touching the glass.
- Do not drop or scratch the bulb.
- Keep dirt and moisture off the bulb.
- Place the used bulb in the new bulb's carton and dispose of it properly.
- Keep halogen bulbs out of the reach of children.

NOTE: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when the bulb is turned on. It either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and wipe the bulb dry.

1. Ensure that the headlamp switch is in the OFF position.
2. Ensure that the ignition switch is in the LOCK position.
3. Remove the headlamp retainers by pulling up and outward.




4. Remove the headlamp electrical connectors.




5. Remove the headlamp from the vehicle.
6. Push and rotate the bulb 1/4 turn counter-clockwise in order to remove the bulbs from the headlamp.

INSTALLATION PROCEDURE



1. Push in and rotate the bulb 1/4 turn clockwise in order to install the bulb to the headlamp.
2. Install the headlamp electrical connectors.




3. Install the headlamp to the vehicle.




4. Install the headlamp retainers by pushing down and inward.