Troubleshooting Hints - Brake Transaxle Shift Interlock

1. The Shift Lever should lock in PARK with the key in the RUN position and the Brake Pedal in the rest position. If the Shift Lever can be moved from the PARK position, with the key in the RUN position and without depressing the Brake Pedal, CHECK Turn Signal operation. If the Turn Signals do not operate correctly, CHECK Fuse #16 (TURN-B/U) to see if it is open (the Turn Signal Flasher is on the same Circuit as BTSI). If the Fuse is open, LOCATE and REPAIR source of the overload, then REPLACE Fuse. If the Fuse is good (Turn Signals operate correctly), continue with diagnostics.
2. With the key in the OFF position, the Shift Lever should not move from the Park position. If it does, the problem may be with the BTSI Solenoid, or the Shift Linkage itself. If the shift linkage is binding. If the shift linkage does not appear to be binding, continue with BTSI Diagnostics.
3. CHECK that ground G110 is clean and tight.
^ CHECK for a broken (or partially broken ) wire inside of the insulation which could cause system malfunction but prove GOOD in a Continuity/Voltage check with a system disconnected. These Circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ CHECK for proper installation of aftermarket Electronic Equipment which may affect the integrity of other systems. (Refer to Troubleshooting Procedures). Diagnostic Aids