On-Vehicle Service

REMOVAL PROCEDURE
The axle vent assembly is on the right side of the axle carrier.
1. Raise the vehicle. Refer to Vehicle Lifting Points.
2. Remove the vent clamp bolt.





3. Remove the hose from the axle nipple.
4. Remove the vent assembly from the hose.
5. Remove the vent hanger clip from the vent hose.
6. Remove the hose clamp from the vent hose.

INSTALLATION PROCEDURE
1. Use a neoprene-type replacement vent hose.
2. Install the hose clamp to the vent hose.
3. Install the vent hanger clip to the vent hose.
4. Install the vent assembly to the vent hose.





5. Install the vent hose to the axle nipple.
6. Install the hose clamp to the axle nipple. Do not kink or twist the hose.
7. Install the vent clamp bolt at the vent assembly.
^ Tighten the bolt to 16 Nm (12 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

8. Lower the vehicle.