Turn Lamps

With the Ignition Switch in the RUN or START position, voltage is applied from the Turn-B/U Fuse to the normally closed pole of the Hazard Switch in the Turn/Hazard Switch. With the Turn/Hazard Switch in the LEFT TURN position, voltage is applied from the Switch to the LT BLU (14) wire and to the YEL (18) wire LH Front Turn, Rear Turn and Indicator Lamps flash ON and OFF as current flow is controlled by the Turn/Hazard Flasher Module, and it continuously opens and closes the circuit (for RH Turn Lamps DK BLU (15) wire and DK ORN (19) wire). With Park Lamps ON and Thin Lamps ON, voltage is applied to both Terminals of the Front Side Marker Lamp causing is to be OFF. When the Front Turn Lamp is OFF, voltage is applied to only one Terminals of the Marker Lamp, causing it to flash ON. The Turn Lamp and Marker Lamp continue to flash ON and OFF in sequence until the Turn Switch is turned OFF.