Intake Manifold Removal

1. Remove the Evaporative Emission (EVAP) canister purge solenoid valve harness.
1.1. Push the quick disconnect clip and hold in place.
1.2. Pull outward on the harness elbow.





2. Remove the Engine Coolant Temperature (ECT) sensor wire connector (if equipped) from the engine wiring harness bracket.
3. Remove the lower intake manifold bolts.
4. Remove the intake manifold assembly.

IMPORTANT: The intake manifold may be removed as an assembly. Do not remove the specific intake manifold components unless component service is required.

Do not allow dirt or debris to enter the fuel system. Ensure that the ends of the fuel system are properly sealed.
Do not disassemble the Central Sequential Fuel Injection (SFI) unit, unless service is required.

5. Remove and discard the lower intake manifold gaskets.