Lower Control Arm Replacement

REMOVAL PROCEDURE





1. Remove the coil spring.
2. Remove the nuts and the bolts from the lower control arm pivot joints.
3. Remove the lower control arm.





4. Remove the bushings from the control arm using a press.

INSTALLATION PROCEDURE





1. Install the bushings using a press.

NOTICE:
^ Avoid pounding the bolts or any excessive force when installing the control arm to the frame.
^ Always inspect the frame attachment hole for elongation greater than 1 mm clearance around the bolt in any direction at any location. If 1 mm gap or other evidence of damage is detected, repair the frame as required.





2. Install the control arm to the frame.
3. Install the new bolts and the nuts that retain the lower control arm to the frame.

Tighten
Tighten the nuts to 155 Nm (115 ft. lbs.).

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

4. Install the coil spring.