Front Wiper Motor
REMOVAL PROCEDURETOOLS REQUIRED
J 39232 Wiper Transmission Separator
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the electrical connector from the wiper motor.
4. Remove the four bolts retaining the wiper system drive module.
5. Remove the wiper drive system module from the vehicle.
6. Remove the drive link from the wiper motor crank arm with the J 39232.
7. Remove the two bolts retaining the wiper motor.
8. Remove the wiper motor from the wiper drive system module.
INSTALLATION PROCEDURE
TOOLS REQUIRED
J 39529 Wiper Transmission Installer
NOTICE: Refer to Fastener Notice in Cautions and Notices.
1. Install the wiper motor onto the wiper drive system module with the two bolts.
Tighten
Tighten the two bolts to 8 N.m (71 lb in).
2. Install the drive link onto the wiper motor crank arm with the J39529.
3. Install the wiper drive system module on the vehicle.
4. Install the tour bolts.
Tighten
Tighten the four bolts to 8 N.m (71 lb in).
5. Connect the electrical connector to the wiper motor.
6. Install the air inlet grille panel.
7. Install the wiper arms.
8. Operate the wipers and check for proper operation.