Spring Shackle Replacement

REMOVAL PROCEDURE
1. Raise the vehicle on a hoist.
2. Support the rear axle in order to relieve the tension from the rear springs using a suitable jack stand.
3. Remove the tire and wheel.
4. Remove the upper retaining bolt from the shackle.
5. Remove the lower retaining bolt from the shackle.
6. Remove the shackle from the vehicle.

INSTALLATION PROCEDURE
1. Install the shackle to the vehicle.
2. Install the lower retaining bolt to the shackle. Use a new bolt and a new nut each time the service is performed.
3. Install the upper retaining bolt to the shackle. Use a new bolt and a new nut each time the service is performed.

Tighten
Tighten the upper shackle retaining bolt and the lower shackle retaining bolt to 90 Nm (67 ft. lbs.).

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

4. Install the tire and wheel. Lower the vehicle.