System Check - Glow Plugs

Diagnostic Chart:

Wiring Diagram:

CIRCUIT DESCRIPTION

The glow plug system is used in order to assist in providing the heat required to begin combustion during engine starting at cold ambient temperatures. The glow plugs are heated before and during cranking, as well as during the initial engine operation. The PCM controls the amount of time the glow plugs are energized by monitoring the coolant temperatures and the glow plug voltage. This system check will check the glow plugs and the glow plug feed circuit coming from the relay.


DIAGNOSTIC AIDS

If the glow plug relay is stuck in the ON position, check for proper operation of glow plugs. When the glow plugs are commanded ON by the scan tool, an internal PCM timer protects the glow plugs from damage by cycling them ON for 3 seconds and then OFF for 12 seconds. Most glow plug system failures are covered by DTC P0380. If no DTCs are stored, the vehicle is hard to start and white smoke is present during cranking or after vehicle is started. The most likely cause of failure is the glow plugs.


TEST DESCRIPTION

The number(s) below refer to the number(s) on the diagnostic table.

1. This step will ensure that the OBD system check is performed.

2. This step will ensure that there are no other DTCs stored that will affect the operation of the glow plug system.

3. This step will check each glow plug for an open.

4. This step will check each glow plug feed circuit for an open.