Turn Signal & Multifunction Switch

Tilt Steering Column - Part 1 Of 2:

Tilt Steering Column - Legend - Part 2 Of 2:

^ Tools Required:
- J 41352 Modular Column Holding Fixture

REMOVE OR DISCONNECT
1. Do steps 1 through 11 under REMOVE OR DISCONNECT, in LOWER SHROUD, UPPER SHROUD.

Removing T/S And Multifunction Switch:

2. Two wire harness straps (22) from steering column wire harness.
3. Steering column bulkhead connector from vehicle wire harness.
4. Axial position assurance connector (23) from electrical (BTSI) actuator (61). (column shift only)
^ Electrical connector from (BTSI) actuator (61).
5. Grey and black connectors of turn signal & multifunction switch (24) from column bulkhead connector.
6. Two pan head tapping screws (13).
7. Turn signal & multifunction switch assembly (24) from column.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Turn signal & multifunction switch assembly (24) to column.
^ With small blade screwdriver compress electrical contact and move multifunction switch (24) into position.
^ Electrical contact must rest on cancelling cam assembly (6).
2. Two pan head tapping screws (13).

Tighten
Tighten screws (13) to 6 Nm (53 lb in).

3. Grey and black connectors of multifunction switch (24) to column bulkhead connector.
4. Electrical connector to electrical (BTSI) actuator (61). (column shift only)
^ Axial position assurance connector (23).
5. Steering column bulkhead connector to vehicle wire harness.
6. Two wire harness straps (22) to steering column wire harness.
7. Do steps 4 through 16 under INSTALL OR CONNECT, in LOWER SHROUD, UPPER SHROUD.