Front
FRONT WHEEL BEARINGS AND/OR HUBREMOVAL PROCEDURE
1. Raise the vehicle. Support the vehicle with safety stands.
NOTICE: Support the caliper with a piece of wire to prevent damage to the brake line.
2. Remove the front brake caliper.
3. Remove the dust cap from the hub/rotor.
4. Remove the cotter pin, the nut, and the washer.
Important: Do not damage the outer bearing and the spindle threads.
5. Remove the rotor from the spindle.
6. Remove the outer bearing.
7. Remove the dust seal. Pry the seat out and discard the seal.
8. Remove the inner bearing.
NOTICE: Do not spin the wheel bearings with compressed air to dry them the wheel bearings may be damaged.
9. Clean all of the parts in a solvent, then air dry.
10. Make sure all of the parts are clean and free of grease.
11. Inspect the rotor.
12. Inspect the bearings and the races for wear or damage.
INSTALLATION PROCEDURE
Important:
^ Make sure that all of the parts are clean and free of grease.
^ Apply an approved high-temperature front wheel bearing grease to the spindle at the inner and outer bearing seat, the shoulder, and the seal seat.
^ Also, finger apply a small amount of grease inboard of each bearing cup in the hub/rotor.
^ Pressure pack the bearings with a grease machine, or hand pack the bearings. Make sure the grease is worked thoroughly into the rollers, the cone, and the cage.
1. Install the inner bearing to the rotor.
2. Apply an additional quantity of grease outboard of the inner bearing.
3. Install the seal.
3.1. Lubricate the seal lip.
3.2. Use a flat plate in order to press the seal down flush with the hub.
3.3. Seat the outer bearing and the cup.
Important: Do not scuff the spindle threads.
4. Install the hub/rotor to the spindle.
5. Install the outer bearing to the hub/rotor.
6. Install the washer.
Important: Adjust the wheel bearings.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.
7. Install the nut.
Tighten
7.1. Tighten the nut to 16 Nm (12 lb ft), while turning the wheel forward by hand.
7.2. Apply grease to the outboard side of the outer bearing.
8. Install the cotter pin.
9. Install the cap to the hub/rotor
10. Install the front brake caliper.
11. Lower the vehicle.