Tire Hoist and Shaft Replacement (Passenger and Cargo)

REMOVAL PROCEDURE
1. Remove the spare tire from the hoist.





2. Remove the retaining bolt from the hoist.





3. Remove the pin and the retainer clip from the hoist and the shaft.





4. Remove the spare tire shaft and guide from the vehicle.





5. Remove the hoist from the crossmember.

INSTALLATION PROCEDURE





1. Install the hoist to the crossmember.





2. Install the spare tire shaft and guide to the vehicle.





3. Install the pin and the retainer clip to the hoist and the shaft.





4. Install the retaining bolt to the hoist.

Tighten
Tighten the bolt to 20 Nm (15 ft. lbs.).

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

5. Install the spare tire to the hoist.