Headlamp Aiming (Sealed Beam)
TOOLS REQUIREDJ 25300-A Headlamp Aimer
Correct the horizontal aiming and the vertical aiming of each headlamp by adjusting the screws. The screws move the mounting bracket against the tension of the coil spring. The screws are in the headlamp bezel area on the models with the sealed beam headlamp. The screw (1) directly above the headlamp adjusts the vertical position. The screw (2) to the side of the headlamp adjusts the horizontal position.
Using the J 25300-A, adjust the headlamps to the specifications required by the state and/or the local authorities. Follow the instructions accompanying the tool.
The screen method can also be used in adjusting the headlamps. Refer to Headlamp Aiming. Follow the same directions. Observe the same tolerances for the aim of the beam. Headlamp Aiming Location (Using Screen Method)