Spotlamp Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.




1. Disconnect the negative battery cable(s).
2. Remove the spotlamp wedge key screw.
3. Remove the handle from the outer tube shaft.
4. Remove the collar.
5. Remove the wire clip.
6. Disconnect the electrical connector.
7. Remove the bracket set screw.




8. Pull the spotlamp and shaft out of the bracket.
9. Remove the spotlamp mounting bracket screws.




10. Remove the mounting bracket from the A pillar.
11. Remove the gasket from the A pillar.

INSTALLATION PROCEDURE




1. Install the gasket to the A pillar.
2. Install the mounting bracket to the A pillar.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the mounting bracket screws.

Tighten
Tighten the mounting bracket screws to 15 N.m (11 lb ft).




4. Install the spotlamp and shaft through the A pillar into the mounting bracket.
5. Rotate the spotlamp to the upright position. Point the spotlamp forward.




6. Install the bracket set screw.
7. Tighten the set screw just enough in order to firmly hold the spotlamp in the upright position.
8. Install the wire clip.
9. Install the collar.
10. Connect the electrical connector.
11. Install the handle onto the outer tube shaft.
12. Install the spotlamp wedge key screw.
13. Connect the negative battery cable(s).