Steering Shaft, Adapter & Bearing, Steering Col Jacket Assembly

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 41352 Modular Column Holding Fixture

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Disable the SIR System; refer to DISABLING THE SIR SYSTEM.
3. Do steps 1 through 7, "REMOVE OR DISCONNECT", Upper/Lower Shroud, STEERING Column Lock CYL Set (With Key).
4. Do all steps "REMOVE OR DISCONNECT", UPPER COLUMN HOUSING COMPONENTS.
5. Coupling & steering shaft assembly (68) or yoke & intermediate steering shaft assembly (64) (Depending on model) from shaft assembly (32).
^ Remove bolt
6. Adapter & bearing assembly (60), and steering shaft assembly (32) from bottom of jacket assembly (58). EVO sensor ASSEMBLY (62) and adapter & bearing assembly (60) from shaft assembly (32).
^ Retaining ring (31) from shaft assembly (32).


INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Retaining ring (31) to steering shaft assembly (32).
2. Shaft assembly (32) through bottom of jacket assembly (58).





3. EVO sensor asm (62) and adapter 8` bearing assembly (60) to steering column jacket assembly (58).
^ Position tab on adapter & bearing assembly (60) with slot in steering column jacket assembly (58) and push together.
4. Coupling & steering shaft assembly (68) or yoke & intermediate steering shaft assembly (64) to shaft assembly (32).

Tighten
^ Tighten bolt and nut to 62 Nm (46 lb ft).

Tighten
^ Tighten Hex Nut and Locking Bolt (65) and (67) to 62 Nm (46 lb ft).

5. Do steps 1 through 5, "INSTALL OR CONNECT", UPPER COLUMN HOUSING COMPONENTS.
6. Do steps 1 through 7, "INSTALL OR CONNECT", COIL ASSEMBLY.
7. Steering column assembly to vehicle.
8. If all service operations are completed, enable the SIR system; refer to ENABLING THE SIR SYSTEM.
9. Negative (-) battery cable.