Forward Clutch Installation

^ Tools Required
- J 38358-A Forward Clutch Assembly Remover/Installer
- J 36850 Transjel(r)





1. Align the direct clutch plates (610, 611).

IMPORTANT: Following installation of the forward clutch assembly, the distance between the top of the speed sensor ring and the pump gasket surface should be approximately 98 - 99 mm (3.85 - 3.89 inch).

2. Use J 38358-A in order to install the forward clutch assembly (602).
3. Install the overdrive carrier thrust bearing (601) (silver side up) onto the forward clutch housing (602). Retain with J 36850 or equivalent.