Checking Fluid

1. The fluid level may be checked hot or cold. To check the fluid level when hot do the following:
- Run engine until the fluid reaches about 80°C (170°F), then shut the engine "OFF."
- Remove the reservoir cap and check the fluid level on the dipstick.
- The fluid level should be between HOT/FULL and COLD/FULL marks on the dipstick.
2. If the fluid level is being checked "COLD," do the following:
- Remove the reservoir cap and check the fluid level on the dipstick.
- The fluid level should be between the bottom of the COLD/FULL mark and the end of the dipstick.
3. If the fluid level is low, add power steering fluid to the proper level and install the reservoir cap.
4. When checking the fluid level after the steering system has been serviced, air must be bled from the system.