Oil Replacement

REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting Caution in General Information.
2. Place a container under the drain plug in order to catch the oil.
3. Remove the fill plug.
4. Remove the drain plug. Allow the oil to drain.

INSTALLATION PROCEDURE
1. Install the drain plug.
- Tighten the New Venture Gear drain plugs to 47 Nm (35 ft. lbs.).
- Tighten the Borg-Warner drain plugs to 25 Nm (18 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install the transfer case oil. Refer to Approximate Fluid Capacities.
3. Fill the transfer case until the oil level is at the bottom of the oil fill plug hole.
4. Install the fill plug.
- Tighten the New Venture Gear drain plugs to 47 Nm (35 ft. lbs.).
- Tighten the Borg-Warner drain plugs to 25 Nm (18 ft. lbs.).

5. Lower the vehicle.