Troubleshooting Hints

1. CHECK GAUGES Fuse 4. If fuse is open, LOCATE and REPAIR source of overload, and REPLACE Fuse.
2. CHECK that ground G200 is clean and tight.
3. CHECK that photocells for dirt or obstruction.
4. CHECK for poor connections at related components and in-line harness connector terminals before component replacement.
^ CHECK for a broken or partially broken wire inside of the insulation which could cause system malfunction but prove GOOD in continuity/voltage CHECK with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ CHECK for proper installation of aftermarket electronic equipment which may affect the integrity of other system.