Battery Cable Replacement-Auxiliary (TP2 - Negative)

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Remove the engine sight shield.
3. Remove the bolt anchoring the negative battery cable to the block.
4. Remove the negative battery cable.

INSTALLATION PROCEDURE
1. Install the negative battery cable.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the bolt anchoring the negative battery cable to the block.

Tighten
Tighten the nut to 25 N.m (18 lb ft).

3. Connect the negative battery cable.

Tighten
Tighten the nut to 17 N.m (13 lb ft).

4. Install the engine sight shield.