Strg Gear Pitman Shaft & Housing Cover Replacement

DISASSEMBLY PROCEDURE





1. Loosen and remove the adjuster lock nut (1).
2. Remove the bolts (2).
3. Rotate the stub shaft (6) using a 12-point socket in order to center the steering gear (7).
4. Remove the following items as an assembly:
- The side cover (8)
- The gasket (3)
- The pitman shaft (4)
5. Remove the pitman shaft (4) from the side cover (8).

ASSEMBLY PROCEDURE





1. Screw the pitman shaft (4) to the side cover (8) until it fully seats to the side cover (8).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the adjuster lock nut (1). Do not tighten the adjuster lock nut (1) until the pitman shaft adjustment is completed.
3. Install the gasket (3) to the side cover (8).
4. Bend the gasket tabs around the edges of the side cover (8).
5. Install the pitman shaft assembly (4) and the side cover (8) to the steering gear housing (7).
6. Install the bolts (2).
- Tighten the bolts (2) to 60 Nm (44 ft. lbs.).
7. In order to adjust the pitman shaft (4), refer to Pitman Shaft Over-Center Preload Adjustment - Off Vehicle.