Rear

REMOVAL PROCEDURE
1. Raise the vehicle on a hoist.
2. Remove the following part from the stabilizer links:
- The lower nuts
- The washers
- The bolts
3. Remove the bolt/screws from the clamp.
4. Remove the clamps and the insulators.
5. Remove the stabilizer shaft.

INSTALLATION PROCEDURE
1. Install the stabilizer shaft to the rear axle.
2. Install the insulators.
3. Install the clamps.
4. Install the bolt to the clamp.
5. Install the lower bolts through the following components:
- The washer
- The stabilizer link
- The washer

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the nuts.
- Tighten the bolts to 34 Nm (25 ft. lbs.).
- Tighten the nuts to 45 Nm (33 ft. lbs.).