Instrument Panel Cluster (IPC) - Bezel Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. For vehicles equipped with tilt wheel, move the steering column to the lowest position, if the vehicle is not equipped with a tilt steering column, you may have to lower the column.
3. Remove the four clips across the top edge, and the four clips across the bottom edge that retain the bezel to the IP by gently pulling toward the inside of the vehicle.
4. Disconnect the electrical connectors from the headlamp switch and the accessory switches.

INSTALLATION PROCEDURE
1. Connect the electrical connectors for the headlamp switch and the accessory switches.
2. Press the bezel into the IP making sure that the clips line up with the holes in the IP.
3. Connect the negative battery cable.