Washer

When the rear window washer switch is pressed, voltage is supplied through CKT 392 (DK GRN) to the solid state control board in the rear window wiper/washer module. The rear window wiper/washer switch also supplies battery voltage through CKT 392 (DK GRN) to the rear window washer pump motor. This starts the wiper cycle and the wash cycle. The washer continues to run as long as the switch is held down. The solid state control board keeps the wipers on for 6 seconds after the washer goes off.

If the washer is switched on during DELAY operation, the wipers run in low speed for 6 seconds. When the wash cycle is completed, the wipers return to the DELAY operation.