Turn Signal & Multifunction Switch - Assemble

ASSEMBLY PROCEDURE





1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.

IMPORTANT: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).

NOTICE: Refer to Fastener Notice in Service Precautions.

- Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





4. Reconnect the turn signal and multifunction switch assembly connector to the SIR coil assembly connector.
5. Attach the wire harness assembly (1) to the wire restraint clip (2).
6. Install the upper and lower shrouds. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift).