Turbo Boost Sensor: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.




1. Remove negative battery cables.
2. Remove the electrical connector.
3. Remove the mounting bolts.




4. Remove the sensor.

INSTALLATION PROCEDURE




1. Install the port gasket on sensor.
2. Install the sensor.

NOTE: Refer to Fastener Notice in Cautions and Notices.




3. Install the mounting bolts.

Tighten
Tighten the mounting bolts to 3.5 N.m (27 lb in).

4. Install the electrical connector.
5. Install the negative battery cables.